DGS-6604 m clear ip ospf
CLI Reference Guide
104
clear ip ospf
Use this command to restart the OSPF process.
clear ip ospf
Syntax None
Default None
Command Mode Privileged EXEC
Usage Guideline This command is used to restart the OSPF routing process. The following is a
situation where this command can be used:
• When a new route-ID is configured, it will not take effect until next time
the switch is booted. When the OSPF process is restarted by this com-
mand, the new router-ID will take effect immediately without having to
reboot the switch.
Example This example shows how to restart all of OSPF processes
Switch>enable
Switch# clear ip ospf
To Next Page
Loading...
