DGS-6604 m resequence access-list
CLI Reference Guide
527
resequence access-list
Use this command to re-sequence the priority of the access-list entries in an
access-list (mac, ip or ipv6 access list).
resequence access-list NAME STARTING-SEQUENCE-NUMBER INCREMENT
Default Disabled
Command Mode Global configuration
Usage Guideline This feature allows the permit and deny entries of a specified access list to be
re-sequenced with an initial priority value determined by the STARTING-
SEQUENCE-NUMBER argument, and continuing in increments determined by
the INCREMENT argument. If the highest priority exceeds the maximum possible
sequence number, then no sequencing occurs.
If entries with no priority are applied, the first entry is assigned a priority of 10,
and successive entries are incremental by 10.
If the user enters an entry without a priority, it is assigned a priority that is 10
greater than the largest priority value (with least priority) in that access list and is
placed at the end of the list.
Example This example shows how to re-sequence the priority of IP access-list, named
R&D
Syntax Description
NAME The name of the MAC, IP or IPv6 access-list to be configured. It can accept up to
32 characters. The syntax is a general string that does not allow space.
STARTING-
SEQUENCE-
NUMBER
Access list entries will be re-sequenced using this initial value. The default value
is 10. The range of possible sequence numbers is 1 through 65535.
INCREMENT The number by which the sequence numbers change. The default value is 10.
For example, if the increment value is 5 and the beginning sequence number is
20, the subsequent sequence numbers are 25, 30, 25, 40, and so on. The range
of INCREMENT is 1 through 65535.
Switch(config)# show access-list ip R&D
10 permit tcp any 10.20.0.0 255.255.0.0
20 permit tcp any host 10.100.1.2
30 permit icmp any any
Switch(config)# resequence access-list R&D 1 2
Switch(config)# show access-list ip R&D
1 permit tcp any 10.20.0.0 255.255.0.0
3 permit tcp any host 10.100.1.2
5 permit icmp any any
To Next Page
Loading...
