DGS-6604 m lldp transmit
CLI Reference Guide
398
lldp transmit
To enable the LLDP advertise (transmit) capability, use the lldp transmit
command in Interface Configuration mode. Use the no form of this command to
disable LLDP transmission.
lldp transmit
no lldp transmit
Syntax This command has no arguments or keywords.
Default LLDP transmit is enabled on all supported interfaces.
Command Mode Interface Configuration mode
Usage Guideline This command is used to enable LLDP transmission on a physical interface.
When LLDP is not running (when the command no lldp run is issued on global
configuration mode), the router doesn't transmit LLDP message.
Example This example shows how to enable LLDP transmission.
This example shows how to disable LLDP transmission.
Switch(config-if)# lldp transmit
Switch(config-if)# no lldp transmit
To Next Page
Loading...
