DGS-6604 m show ip rip interface
CLI Reference Guide
692
show ip rip interface
Display interface specific information for RIP.
show ip rip interface [INTERFACE-ID]
Default None
Command Mode User EXEC or any configuration mode
Usage Guideline show ip rip interface will display interface specific information, such as:
authentication, send version, receive version, and v2 broadcast mode.
Example The following output shows the show ip rip interface command:
Syntax Description
interface
INTERFACE-ID
(Optional) Specifies the interface ID to display the RIP information for. If no
INTERFACE-ID is specified, the RIP information on all interfaces will be shown.
Switch# Show ip rip interface
vlan1 is up, line protocol is up
Routing Protocol: RIP
Receive RIP packets
Send RIP packets
Send v2-broadcast: Disabled
Authentication Mode: text
Passive interface: Disabled
Split horizon: Enabled with Poisoned Reversed
IP interface address:
10.72.63.80/8
vlan2 is up, line protocol is up
Routing Protocol: RIP
Receive RIP packets
Send RIP packets
Send v2-broadcast: Disabled
Authentication Mode: text
Passive interface: Disabled
Split horizon: Enabled with Poisoned Reversed
IP interface address:
20.72.63.80/8
To Next Page
Loading...
