DGS-6604 m show ip route
CLI Reference Guide
693
show ip route
To display the current state of the routing table, use the show ip route
command.
show ip route [IP-ADDRESS [MASK] | [database] [PROTOCOL | connected | static]]
Default None
Command Mode User EXEC or any configuration mode
Usage Guideline The show ip route database static command displays, for example, all static
routes with name and distance information, including active and inactive entries.
Display all active static routes with both the show ip route and show ip route
static commands.
Syntax Description
IP-ADDRESS (Optional) Address about which routing information should be displayed.
MASK (Optional) Argument specifying a subnet mask.
PROTOCOL (Optional) The name of a routing protocol, specifying a routing protocol, use one
of the following keywords: bgp, ospf, and rip.
database (Optional) Specifies that the routing database is to be shown and the active
routes populated in the forwarding database is prefixed with an asterisk.
connected (Optional) Display all connected local interface routes.
static (Optional) Display all static routes.
To Next Page
Loading...
