DGS-6604 m spanning-tree ( Global configuration )
CLI Reference Guide
859
spanning-tree ( Global configuration )
Use this command to enable STP mode. Use the no form of the command to
disable STP.
spanning-tree
no spanning-tree
Syntax None
Default Disable
Command Mode Global configuration
Usage Guideline When the no spanning-tree command is used globally to disable STP, an STP
BPDU will be treated as a normal multicast packet and it will be flooded to the
other VLAN member ports.
Example This example shows how to enable STP and MSTP mode as the default mode.
Verify the settings by entering the show spanning-tree command.
Switch(config)# spanning-tree
Switch(config)#
To Next Page
Loading...
