DGS-6604 ip dvmrp
CLI Reference Guide
262
ip dvmrp
Use this command to enable DVMRP on the current interface. Use the no form to
disable DVMRP on the interface.
ip dvmrp
no ip dvmrp
Syntax None
Default Disabled
Command Mode VLAN interface configuration
Usage Guideline This command is only valid for the VLAN interface.
The VLAN interface will have DVMRP protocol enabled (or disabled).
Before enabling DVMRP function on an interface, it is necessary to enable IP
multicast routing with the ip multicast-routing command in global configuration
mode.
Only one multicast routing protocol can be enabled on an interface, make sure
no other multicast routing protocol is configured before DVMRP is enabled . If
another protocol is enabled, an error message is displayed.
Example This example shows how to enable the DVMRP protocol on the interface
VLAN 1.
Verify the settings by the show ip dvmrp interface command.
Switch(config)# interface vlan1
Switch(config-if)# ip dvmrp
To Next Page
Loading...
