DGS-6604 m show ip dvmrp prune
CLI Reference Guide
639
show ip dvmrp prune
Use this command to display DVMRP upstream prune state information.
show ip dvmrp prune
Syntax None
Default None
Command Mode User EXEC or any configuration mode
Usage Guideline Display DVMRP upstream Prune state information.
Example This example shows how to displays prune information.
Display Field
Descriptions
Description of significant display fields.
DGS-6600:15#show ip dvmrp prune
Flags: P=Pruned,D=Holddown,N=NegMFC
Source Group State ExpTime Prune/Graft
Network Address ReTransmit-Time
------------------ ---------------- ----- ------------ ---------------
10.0.7.101/32 239.255.255.250 P.. 0DT1H45M44S Off
10.0.7.131/32 239.255.255.250 P.. 0DT1H47M30S Off
10.1.52.99/32 229.55.150.208 P.N 0DT1H44M36S 0DT0H3M50S
Total Entries: 3
Display Field Description
Source Network The address of the source IP address or source network.
Group Address The IP group address.
State P: The upstream state is in Prune state.
D: The entry is in Hold-Down state. In this state, a negative multicast
forwarding cache (ip mroute) entry will be added.
N: Negative Multicast forwarding cache (ip mroute) is installed.
ExpTime The amount of time remaining before this prune will expire.
Prune/Graft ReTransmit
Time
The remaining time before retransmitting a Prune or Graft. When "P" flag is
set in the "State" field, this timer would represent the Prune retransmit timer,
otherwise, it would represent the Graft retransmit timer.
To Next Page
Loading...
