DGS-6604 ipv6 ospf dead-interval
CLI Reference Guide
352
ipv6 ospf dead-interval
To set the time period used, during which hello packets are not detected, before
neighbors declare the router down, use the ipv6 ospf dead-interval command.
To return to the default time, use the no form of this command.
ipv6 ospf dead-interval SECONDS [instance-id INSTANCE-ID]
no ipv6 ospf dead-interval [instance-id INSTANCE-ID]
Default Seconds: 40
Default INSTANCE-ID: 0
Command Mode Interface configuration
Usage Guideline The interval is advertised in router hello packets. This value must be the same for
all routers and access servers on a specific network.
Example The following example sets the IPv6 OSPF dead interval to 60 seconds.
Syntax Description
SECONDS Specifies the interval in seconds. The value must be the same for all nodes on a
specific network.It can be a value in the range from 1 to 65535.
INSTANCE-ID (Optional) Instance identifier. To change this ID, please configure "no" command
first. The valid setting is from 0 to 255.
Switch > enable
Switch # configure terminal
Switch (config)# interface vlan1
Switch (config-if)# ipv6 ospf dead-interval 60
To Next Page
Loading...
