DGS-6604 m show ipv6 ospf interface
CLI Reference Guide
713
show ipv6 ospf interface
To display OSPF-related interface information, use the show ipv6 ospf
interface command.
show ipv6 ospf interface [IFNAME]
Default None
Command Mode User EXEC
Usage Guideline None.
Example show ipv6 ospf interface Standard Output Example: The following is sample
output from the show ipv6 ospf interface command.
The result after executing this command is as follows.
Syntax Description
IFNAME (Optional) Interface type and number. If no option is specified, applying the
command displays the entire IPv6 OSPF process.
Switch > enable
Switch # show ipv6 ospf interface
vlan2 is up, line protocol is up
Interface ID 1026
IPv6 Prefixes
fe80::a01:2ff:fe36:2/64 (Link-Local Address)
3ffe:4::30/64
OSPFv3 Process (null), Area 0.0.0.1 (active)
MTU 1500, Instance ID 0
Router ID 10.76.37.30, Network Type BROADCAST, Cost: 1 (default)
Transmit Delay is 1 sec, State BDR, Priority 1
Designated Router (ID) 10.76.37.3
Interface Address fe80::219:5bff:fef5:2cc1
Backup Designated Router (ID) 10.76.37.30
Interface Address fe80::a01:2ff:fe36:2
Timer intervals configured, Hello 10, Dead 40, Retransmit 5
Hello due in 0DT0H0M5S
Neighbor Count is 1, Adjacent neighbor count is 1
Hello received 48 sent 46, DD received 5 sent 3
LS-Req received 1 sent 1, LS-Upd received 11 sent 10
LS-Ack received 8 sent 6, Discarded 00
To Next Page
Loading...
