DGS-6604 ipv6 enable
CLI Reference Guide
340
ipv6 enable
This command is used to enable and disable the IPv6 protocol on an interface of
the switch. The no form of this command can disable the IPv6 protocol.
ipv6 enable
no ipv6 enable
Syntax None
Default The default IPv6 incidence status is "Disable".
Command Mode The VLAN interface must be created before.
Usage Guideline The interface must be created before used ipv6 enable command. When the
interface up, ipv6 enable will also add link-local address to the interface and vice
versa. When global address had existed in the interface and using the "no ipv6
enable" command, it will take no effect (link-local address should not be
removed).
Example This example shows how to enable the IPv6 protocol:
Switch > enable
Switch # configure terminal
Switch (config) # interface vlan1
Switch (config-if) # ipv6 enable
Switch (config-if) #
To Next Page
Loading...
