DGS-6604 m show ip mroute
CLI Reference Guide
654
show ip mroute
Use this command to display the content of the IP multicast routing table.
show ip mroute [{ [group-addr GROUP-ADDRESS] [source-addr NETWORK-ADDRESS]
[summary]} |static]
Default None
Command Mode User EXEC or any configuration mode
Usage Guideline Displays the content of the IP multicast table.
The “Uptime” timer describes the time elapsed since the entry was created.
The “Expires” timer is a keep-alive timer for the multicast data stream. The
Expires timer value is based on either the PIM Sparse and Dense Mode RFCs
(RFC 4601 and RFC 3973) or DVMRP. If the multicast data continues to arrive at
the device, the timer will renew itself.
If network address is specified, the switch displays the entries with source
addresses that match the specified address.
Syntax Description
group-addr
GROUP-ADDRESS
(Optional) Specifies the Group IP address.
source-addr
NETWORK-ADDRESS
(Optional) Specifies the Source IP network address.
summary (Optional) Displays a one-line, abbreviated summary of each entry in
the IP multicast routing table.
static (Optional) Displays the multicast static routes
To Next Page
Loading...
