D-Link DGS-6600-48TS

DGS-6604 m show dot1v
CLI Reference Guide
595
show dot1v
Use the show dot1v command to display the setting for the configuration of
VLAN protocols.
show dot1v {protocol-group [GROUP-ID [ , | - ]] | interface [INTERFACE-ID [ , | - ] ]}
Default None
Command Mode User EXEC or any configuration mode
Usage Guideline Use the show dot1v command to display the current protocol VLAN status.
Show the protocol VLAN group list table using the show dot1v protocol-group
command. Show the protocol VLAN binding of the ports using the show dot1v
interface command.
Example This example shows how to display protocol VLAN binding of interface ports 3.1
to 3.3.
Syntax Description
protocol-group Show the protocol VLAN table entry information.
GROUP-ID Specifies the dot1v protocol table entry number.
interface Show the protocol VLAN group binding information of the ports.
INTERFACE-ID Specifies the interface to display.
, (Optional) Specifies a series of interfaces or GROUP-ID, or separate a range of
interfaces from a previous range. No space before and after the comma.
- (Optional) Specifies a range of interfaces or GROUP-ID. No space before and
after the hyphen.
Switch# show dot1v interface eth3.1-3.3
Interface dot1v Group ID/Binding-VLAN
--------- ------------------------------------------
eth3.1 1/1
eth3.2 10/3000, 11/3001, 12/3002
eth3.3 2/100
Switch#