DGS-6604 m show startup-config
CLI Reference Guide
763
show startup-config
Use this command to display the content of the startup configuration file.
show startup-config
Syntax None
Default None
Command Mode Privilege EXEC at level 15
Usage Guideline Use show startup-config command to display the system configuration
contents of the file which is specified with the boot config command. If no boot
config command is applied, the factory default system configuration content is
displayed.
Example The following example shows how to display the content of the startup system
configuration file:
Switch:15(config)#show startup-config
#Boot configuration file=flash:\configurations\def_usr.conf
#Switch Chassis-based High-Speed Switch
#Firmware Version:1.00.001
To Next Page
Loading...
