DGS-6604 m name
CLI Reference Guide
441
N
name
Use the name command to set the name of an MST region. To return to the
default name, use the no form of this command.
name NAME
no name
Default The default value for name is the Bridge MAC address.
Command Mode MST configuration
Usage Guideline If two or more switches have the same VLAN mapping and configuration version
number, the switches are considered to be in different MST regions if the region
names are different. Use the name command to differentiate MST regions.
Caution: Use care when the name command is used to set the name of an MST
region. A mistake can put the switch in a wrong or different region. The MST
region name is a case-sensitive parameter.
Example This example shows how to configure the MSTP configuration name to 'alpha'.
Verify the settings by entering the show spanning-tree mst configuration
command.
Syntax Description
NAME The name given for a specified MST region. The name string has a maximum
length of 32 characters and the type is a general string which allows spaces.
Switch(config)#spanning-tree mst configuration
Switch(config-mst)# name alpha
To Next Page
Loading...
