DGS-6604 ip rip authentication mode
CLI Reference Guide
315
ip rip authentication mode
To configure the type of authentication used in Routing Information Protocol
(RIP) Version 2 packets, use the ip rip authentication mode command in
interface configuration mode. Use the no form of the command to disable the
authentication function.
ip rip authentication mode {text | md5}
no ip rip authentication mode
Default Clear text authentication (text)
Command Mode Interface configuration
Usage Guideline Only VLAN interfaces at which IP addresses are configured are valid interfaces
for this command.
RIP Version 1 does not support authentication. This command only affects
RIPv2.
Example The following example shows how to configure the authentication mode of the
interface to md5 at interface VLAN 2:
Verify the settings by entering the show ip rip interface command.
Syntax Description
text Clear text authentication.
md5 Keyed Message Digest 5 (MD5) authentication.
Switch(config)# interface vlan2
Switch(config-if)# ip rip authentication mode md5
To Next Page
Loading...
