D-Link DGS-6600-48TS

DGS-6604 m snmp-server
CLI Reference Guide
841
Sn
snmp-server
To enable the Simple Network Management Protocol (SNMP) agent, use the
snmp-server command. To disable the SNMP agent, use the no form of this
command.
snmp-server
no snmp-server
Syntax None
Default Disabled
Command Mode Global configuration
Usage Guideline The remote SNMP manager sends SNMP requests to agents and receives
SNMP responses and notifications from agents. When the SNMP agent is
enabled, the remote SNMP manager can query SNMP agents and send SNMP
traps.
Examples This example shows how to enable the SNMP server.
This example shows how to disable the SNMP server.
Verify the settings by entering the show snmp-server command.
Switch(config)# snmp-server
Switch(config)#
Switch(config)# no snmp-server
Switch(config)#