DGS-6604 m show ipv6 rip database
CLI Reference Guide
719
show ipv6 rip database
To display information about current IPv6 RIP processes, use the show ipv6 rip
database command.
show ipv6 rip database
Default None
Command Mode User EXEC
Usage Guideline The information displayed by the show ipv6 rip database command is useful
when debugging RIPng routing operations.
Examples The following is sample output from the show ipv6 rip database command.
The result after executing this command is as follows.
Syntax Description
database If specified the command displays the details of the entries in the specified RIP
IPv6 routing table.
Switch > enable
Switch # show ipv6 rip database
Codes: R - RIP, Rc - RIP connected, Rs - RIP static,
K - Kernel, C - Connected, S - Static, O - OSPF, I - IS-IS, B - BGP
Network Next Hop If Met Time
R 3ffe:1::/64 fe80::219:5bff:fef5:2cc1 vlan2 2
0DT0H2M31S
R 3ffe:2::/64 fe80::219:5bff:fef5:2cc1 vlan2 2
0DT0H2M31S
Rc 3ffe:3::/64 :: vlan3 1
Rc 3ffe:4::/64 :: vlan2 1
Total Entries: 4 entries, 4 routes
To Next Page
Loading...
