DGS-6604 ip ospf priority
CLI Reference Guide
292
ip ospf priority
Use this command to set the router priority to determine the designated router for
the network. The no form of this command will reset the priority to the default
value.
ip ospf priority PRIORITY
no ip ospf prority
Default PRIORITY: 1
Command Mode Interface configuration
Usage Guideline Set the priority to help determine the OSPF Designated Router (DR) for a
network. If two routers attempt to become the DR, the router with the higher
router priority becomes the DR. If the router priority is the same for two routers,
the router with the higher router ID takes precedence.
Only routers with nonzero router priority values are eligible to become the
designated or backup designated router. Configure router priority for multi-
access networks (not point-to-point) only.
Example The following example shows setting the OSPF priority value to 3 on VLAN 1
interface.
Verify the settings by entering the show ip ospf interface command.
Syntax Description
PRIORITY Specifies the priority of the router on the interface. The range is 0 to 255.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ip ospf priority 3
To Next Page
Loading...
