DGS-6604 m spanning-tree mst hello-time
CLI Reference Guide
870
spanning-tree mst hello-time
Use this command to configure the per port hello time used in MSTP version.
spanning-tree mst hello-time SECONDS
Default The default value for hello-time is 2.
Command Mode Interface configuration
Usage Guideline The MSTP hello-time is only referenced in MSTP mode.
Both physical ports and port-channel interfaces are valid for this command.
Example This example shows how to configure the port hello-time to 1 for port 2.1
Verify the settings by entering the show spanning-tree mst interface
command.
Syntax Description
SECONDS Used to determine the time interval to send one BPDU at the designated Port.
The range is 1 to 10.
Switch(config)#interface eth2.1
Switch(config-if)#spanning-tree mst hello-time 1
To Next Page
Loading...
