DGS-6604 m spanning-tree mst priority
CLI Reference Guide
871
spanning-tree mst priority
Use this command to configure the bridge priority value for the selected MSTP
instance. Use the no form of the command to return the setting to the default
setting.
spanning-tree mst INSTANCE-ID priority PRIORITY
no spanning-tree mst INSTANCE-ID priority
Default PRIORITY: 32768
Command Mode Global configuration
Usage Guideline The number of supported MSTP instances is project dependent.
This priority has same definition as the “spanning-tree priority” on page 873
within the STP command set, but it can specify different priorities for each distinct
MSTP instance.
Example This example shows how to configure bridge priority for the MSTP instance 2.
Verify the settings by entering the show spanning-tree mst command.
Syntax Description
INSTANCE-ID Specifies the MSTP instance identifier. Valid values are from 0 to 63. The
number of supported MSTP instances is project dependent. Instance 0
represents the default instance, CIST.
PRIORITY Specifies the bridge priority. The priority value must be divisible by 4096 and the
range is from 0 to 61440.
Switch# configure terminal
Switch(config)#spanning-tree mst 2 priority 0
Switch(config)# end
To Next Page
Loading...
