DGS-6604 ipv6 rip split-horizon poisoned
CLI Reference Guide
360
ipv6 rip split-horizon poisoned
To configure the poison reverse processing of IPv6 RIP router updates, use the
ipv6 rip split-horizon poisoned command. To disable the poison reverse
processing of IPv6 RIP updates, use the no form of this command.
ipv6 rip split-horizon poisoned
no ipv6 rip split-horizon
Syntax None
Default Poison reverse is configured.
Command Mode Interface configuration
Usage Guideline This command configures poison reverse processing of IPv6 RIP router updates.
When poison reverse is configured, routes learned via RIP are advertised with an
unreachable metric out from the interface over which they were learned.
If both poison reverse and split horizon are configured, then simple split horizon
behavior is replaced by poison reverse behavior.
Example The following example configures poison reverse processing for the IPv6 RIP
routing process.
Switch > enable
Switch # configure terminal
Switch (config)# interface vlan1
Switch (config-if)# ipv6 rip split-horizon poisoned
To Next Page
Loading...
