DGS-6604 m revision
CLI Reference Guide
528
revision
To set the revision number for the MST configuration, use the revision
command. To return to the default settings, use the no form of this command.
revision VERSION
no revision
Default The default value for revision-level is 0.
Command Mode MST configuration mode.
Usage Guideline If two switches have the same configuration, but, have different revision
numbers, then they are considered to be part of two different regions.
Caution: Be careful when using the revision command to set the revision
number of the MST configuration because a mistake can put the switch in a
different region.
Example This example shows how to configure the revision level of MSTP configuration to
2.
Verify the settings by entering the show spanning-tree mst configuration
command.
Syntax Description
REVISION The same given name with different revision levels also represents different MST
regions. The range is 0 to 65535.
Swtich(config)# spanning-tree mst configuration
Switch(config-mst)#revision 2
To Next Page
Loading...
