DGS-6604 m show ipv6 ospf neighbor
CLI Reference Guide
714
show ipv6 ospf neighbor
To display IPv6 OSPF neighbor information on a per interface basis, use the
show ipv6 ospf neighbor command.
show ipv6 ospf [PROCESS-ID] neighbor [IFNAME | NEIGHBOR-ID] [detail]
Default None
Command Mode User EXEC
Usage Guideline The keywords can be appended to all other keywords used with the show ipv6
ospf neighbor command to display the information desired.
Example The following is sample output from the show ipv6 ospf neighbor command
with the detail keyword.
The result after executing this command is as follows.
Syntax Description
PROCESS-ID (Optional) Internally used identification parameter for an IPv6 OSPF routing
process. It is locally assigned and can be any positive integer. A unique value is
assigned for each IPv6 OSPF routing process.
IFNAME (Optional) Interface type and number. If no option is specified, the command
applies to the entire IPv6 OSPF process.
NEIGHBOR-ID (Optional) Neighbor ID. It can be specified as either a decimal value or as an
IPv4 address.
detail (Optional) Displays all neighbors in detail; lists all neighbors.
Switch > enable
Switch # show ipv6 ospf neighbor
The result after executing this command is as follows.
OSPFv3 Process (null)
Neighbor ID Pri State Dead Time Interface Instance ID
10.76.37.3 1 Full/DR 0DT0H0M33S vlan2 0
10.76.37.3 1 Full/ - 0DT0H0M38S VLINK1 0
Total Entries: 2
To Next Page
Loading...
