DGS-6604 m erpi tc-propagation
CLI Reference Guide
204
erpi tc-propagation
Use the erpi tc-propagation command to enable topology change propagation of
the sub ERP instance. Use the no form of this command to disable topology
change propagation.
erpi INSTANCE-ID tc-propagation
no erpi INSTANCE-ID tc-propagation
Default Disabled
Command Mode ERPS domain configuration mode
Usage Guideline The command setting only takes effect for the sub ERP instance.
Example The following example shows how to enable tc propagation state of sub ERP
instance 2 in ERPS domain 1:
The following example shows how to disable tc propagation state of sub ERP
instance 2 in ERPS domain 1:
Syntax Description
INSTANCE-ID Specifies the identifier of the sub ERP instance. The valid range is 1 to 4095.
Switch(config)# erps domain 1
Switch(config-erps-domain)# erpi 2 tc-propagation
Switch(config-erps-domain)#
Switch(config)# erps domain 1
Switch(config-erps-domain)# no erpi 2 tc-propagation
Switch(config-erps-domain)#
To Next Page
Loading...
