DGS-6604 m lldp tx-interval
CLI Reference Guide
400
lldp tx-interval
To set the LLDPDUs transmission interval on the switch, use the lldp tx-interval
command. Use the no form of this command to return to the default settings.
lldp tx-interval SECONDS
no lldp tx-interval
Default 30 seconds
Command Mode Global configuration
Usage Guideline This interval controls the rate at which LLDP packets are sent.
Examples This example shows how to set LLDP updates are sent every 50 seconds.
This example shows how to set LLDP transmission interval to default value:
Syntax Description
SECONDS Specifies the interval between consecutive transmissions of LLDP
advertisements on each physical interface. The range os from 5 to 32768
seconds.
Switch(config)# lldp tx-interval 50
Switch(config)# no lldp tx-interval
To Next Page
Loading...
