DGS-6604 m mac address-table aging-time
CLI Reference Guide
416
mac address-table aging-time
Use this command to set the length of time that a dynamic entry remains in the
MAC address table.
mac address-table aging-time SECONDS
Default SECONDS: 300
Command Mode Global configuration
Usage Guideline Set the aging time to 0 to disable the MAC address table aging out function.
Example This example shows how to set the aging time to 200 seconds:
Verify the setting by entering the show mac address-table aging-time
command.
Syntax Description
SECONDS Aging time in seconds. The valid range is 0 or 10 to 1000000 seconds. 0 means
that the aging function is disabled so entries never age out.
Switch(config)# mac address-table aging-time 200
To Next Page
Loading...
