DGS-6604 m passive-interface
CLI Reference Guide
463
P
passive-interface
Use the passive-interface command to disable sending OSPF protocol packets
on an interface. To re-enable sending and receiving routing updates, use the no
form of this command.
passive-interface IFNAME
no passive-interface IFNAME
Default Routing updates are sent on the interface.
Command Mode Router configuration
Usage Guideline The valid interface for this configuration is VLAN.
If an interface is passive, no adjacency can be formed on the passive interface
and the OSPF protocol packets are not sent or received through the specified
interface. However, the network of the passive interface will be advertised
through another non-passive interface.
Example This command shows how to set interface VLAN 1 to the passive mode.
Verify the settings by entering the show ip ospf interface command.
Syntax Description
IFNAME Specifies a layer 3 interface (VLAN).
Switch# configure terminal
Switch (config)# router ospf
Switch(config-router)##passive-interface vlan1
To Next Page
Loading...
