DGS-6604 m snmp-server location
CLI Reference Guide
853
snmp-server location
Use this command to configure the system location information. Use the no
snmp-server location command to set the system location information to empty.
snmp-server location TEXT
no snmp-server location
Default No system location string is set.
Command Mode Global configuration.
Usage Guideline Configure the system location information on the switch.
Example This example shows how to set up the system location information with string HQ
15F.
Verify the settings by entering the show snmp-server command.
Syntax Description
location TEXT A string that describes the system location information.
The maximum length is 255 characters (please refer to RFC1213 for the
maximum length in detail). The syntax is a general string that allows spaces.
Switch(config)# snmp-server location HQ 15F
To Next Page
Loading...
