DGS-6604 ip multicast-routing
CLI Reference Guide
285
ip multicast-routing
Use this command to enable IP multicast routing. Use the no form of this
command to disable IP Multicast routing.
ip multicast-routing
no ip multicast-routing
Syntax None
Default Disabled
Command Mode Global configuration
Usage Guideline If the no ip multicast-routing command is used, the device stops routing
multicast packets even when the protocols are enabled.
Example This example shows how to enable IP multicast routing.
Verify the settings by the show system protocol-state command.
Switch(config)# ip multicast-routing
To Next Page
Loading...
