DGS-6604 m show channel-group
CLI Reference Guide
580
show channel-group
Use this command to display the information of channel groups.
show channel-group [[channel [CHANNEL-NO] [detail | neighbor | protocol]] | load-balance |
sys-id]
Default None
Command Mode User EXEC or any configuration mode
Usage Guideline Use the keyword channel to display the port-channel information. If the
arguments: detail, neighbor or protocol are not specified, then the switch will
display detailed information for the specified port-channels.
If the port-channel number is not specified, then all port-channels will be
displayed.
If the arguments: channel, load-balance and sys-id are specified for the show
channel-group command, only summary channel-group information will be
shown.
Examples This example shows how to display the neighbor information for port-channel 3.
Syntax Description
CHANNEL-NO Channel group ID.
channel (Optional) Display information for specified port-channels.
detail (Optional) Display detailed channel group information.
neighbor (Optional) Display neighbor information.
protocol (Optional) Display the protocol (static or LACP) that is being used in the channel
group.
load-balance (Optional) Display the load balance information.
sys-id (Optional) Display the system identifier that is being used by LACP.
Switch> show channel-group channel 3 neighbor
S - Device is requesting Slow LACPDUs, F - Device is requesting Fast LACPDUs,
A - Device is in Active mode, P - Device is in Passive mode,
Partner Partner Partner Partner
Port System ID PortNo Flags Port_Pri.
-------------------------------------------------------------------
eth3.1 32768,00-07-eb-49-5e-80 12 SP 32768
eth3.2 32768,00-07-eb-49-5e-80 13 SP 32768
Switch>
To Next Page
Loading...
