DGS-6604 m show ip igmp group
CLI Reference Guide
641
show ip igmp group
Used to display IGMP group information on an interface
show ip igmp group [IP-ADDRESS | interface INTERFACE-ID] [detail]
Default None
Command Mode User EXEC or any configuration mode
Usage Guideline User can display IGMP group information by using this command. The following
examples cover different versions of IGMP. The uptime means the time elapsed
since the entry is created. The expire time means the time that the entry will be
removed if there is no refresh of the entry,
Examples This example shows how to display IGMP group information for interface VLAN
1000.
Display Field
Descriptions
show ip igmp group Field Descriptions.
Syntax Description
IP-ADDRESS (Optional) Specifies the Group IP address to display. If no IP address is
specified, all IGMP group information will be displayed.
interface
INTERFACE-ID
(Optional) Specifies the interface to display. If no interface is specified, IGMP
group information of all interfaces where IGMP is enabled will be displayed.
detail (Optional) Specifies to show the additional information (Uptime, Expires, Group
mode and Last reporter).
Switch#show ip igmp group interface vlan1000
Interface Group Address Uptime Expires Last Reporter
-------------------------------------------------------------------
vlan1000 224.0.1.149 0DT0H0M9S 0DT0H4M15S 10.10.0.91
Total Entries : 1 entries, 2 records
Switch#
Field Description
entries The number of the igmp group table display.
records The number of the group records and source records in the igmp group table.
To Next Page
Loading...
