D-Link DGS-6600-48TS

DGS-6604 m show ip igmp snooping
CLI Reference Guide
645
show ip igmp snooping
Use this command to display IGMP Snooping information on the switch.
show ip igmp snooping [VLAN VLAN-ID]
Default None
Command Mode User EXEC or any configuration mode
Usage Guideline The IGMP Snooping information can be displayed using this command. If the
specified VLAN does not exist or IGMP Snooping is disabled at the VLAN, an
error message will be displayed.
Example This example shows how to display IGMP Snooping configurations.
Syntax Description
VLAN VLAN-ID (Optional) Specifies a VLAN. The VLAN ID range is 1 to 4094.
If no VLAN is specified, then this command shows IGMP Snooping Information
for all VLANs where IGMP Snooping is enabled (i.e. all IGMP Snooping enabled
VLAN interfaces).
Switch> show ip igmp snooping
IGMP Snooping is enabled in the following VLANs
Codes- v3:IGMP v3 host compatibility mode, v2: IGMP v2 host compatibility mode
v1:IGMP v1 host compatibility mode
Vlan Querier state Querier Router Immediate Timer State
Leave
----- ------------- --------------- --------- ------------
(v3)1 Enabled Active Enabled -
(v2)2 Disabled - Disabled 0DT0H4M10S
(v3)3 Enabled Non-active Enabled 0DT0H3M12S
Total number of VLANs = 3
Switch>