DGS-6604 ipv6 nd managed-config-flag
CLI Reference Guide
342
ipv6 nd managed-config-flag
This command is used to turn on the IPv6 RA (router advertisement)
management configure flag setting on an interface of this switch. The no form of
this command turns off this flag.
ipv6 nd managed-config-flag
no ipv6 nd managed-config-flag
Syntax None
Default Off
Command Mode VLAN interface configuration
Usage Guideline The VLAN interface must be created first before this command can be used.
Example This example shows how to configure IPv6 manage config flag setting:
Switch > enable
Switch # configure terminal
Switch (config) # interface vlan1
Switch (config-if) # ipv6 nd managed-config-flag
Switch (config-if) #
To Next Page
Loading...
