DGS-6604 based-on c-vid
CLI Reference Guide
60
based-on c-vid
This command is used to specify the customer vlan ID (C-VID) as a rule for IP
address assignment from the DHCP address pool. Use the no form of the
command to remove the C-VID rule from DHCP address pool.
based-on c-vid V-ID [,|-]
no based-on c-vid V-ID [,|-]
Default None
Command Mode DHCP pool configuration
Usage Guideline This command is used to create the address binding rule for the DHCP address
pool. The based-on c-vid command creates the address binding rules in an
incremental way. That is, all of the C-VIDs created by based-on c-vid
commands take effect on the corresponding DHCP address pool. However this
command will be combined with logical AND operations with the other rules set
by other based-on commands. For example if the first rule is based-on c-vid
100 and there is another based-on s-vid 200 command, then the address pool
will only assign an IP address to the client with C-VID=100 and S-VID=200.
Examples The following sets a rule used for IP address assignment based on C-VID 100 or
200 from the DHCP address pool1.
Then the rule is added to and now based on C-VID 100/ 200 and S-VID 1000.
Syntax Description
V-ID [,|-] Specifies the V-ID list.
switch(config)#ip dhcp pool pool1
switch(config-dhcp)#based-on c-vid 100,200
switch(config-dhcp)#based-on s-vid 1000
To Next Page
Loading...
