DGS-6604 m router rip
CLI Reference Guide
538
router rip
Use the command to configure the RIP routing process. To turn off the RIP
routing process, use the no form of this command.
router rip
no router rip
Syntax None
Default Not configured
Command Mode Global configuration
Usage Guideline This command is used to enable the RIP function and enter the Router
configuration mode of RIP protocol.
Executing the no form of the command, will remove the configuration in the
router mode.
Example The following example shows how to begin the RIP routing process:
Verify the settings by entering the show ip protocols rip command.
Switch# configure terminal
Switch(config)# router rip
Switch(config-router)# end
To Next Page
Loading...
