DGS-6604 ipv6 ospf retransmit-interval
CLI Reference Guide
355
ipv6 ospf retransmit-interval
This command specifies the time between link-state advertisement (LSA)
retransmissions for adjacencies belonging to an interface.
ipv6 ospf retransmit-interval SECONDS [instance-id INSTANCE-ID]
no ipv6 ospf retransmit-interval [instance-id INSTANCE-ID]
Default Seconds: 5
INSTANCE-ID: 0
Command Mode Interface configuration
Usage Guideline After sending an LSA to a neighbor, the router keeps the LSA until it receives an
acknowledgement. In case the router does not receive an acknowledgement,
during the set time (the retransmit interval value), it retransmits the LSA. Set the
retransmission interval value conservatively to avoid needless retransmissions.
The interval should be greater than the expected round-trip delay between two
routers.
Example The following example sets the retransmit interval value to 6 seconds.
Syntax Description
SECONDS The interval the router waits before it retransmits a packet. The valid setting is 1-
65535.
INSTANCE-ID (Optional) Instance identifier. In order to change this ID, configure the "no"
command first. The valid setting is from 0 to 255.
Switch > enable
Switch # configure terminal
Switch (config) # interface vlan1
Switch (config-if)# ipv6 ospf retransmit-interval 6
To Next Page
Loading...
