DGS-6604 m show loopback-detection
CLI Reference Guide
726
This example shows current loopback detection setting for vlan-based mode.
This example shows all interface settings.
Switch# show loopback-detection
Status : Enabled
Mode : VLAN-Based
Interval : 20 sec
Interface LoopDetect State Result Time Left(sec)
------------- --------------------- ------------------- ---------------
eth3.1 Enabled Normal
eth3.8 Enabled Normal
eth4.5 Enabled Loop on Vlan 2 120
Loop on Vlan 3 115
Switch# show loopback-detection interface
Interface Loopdetect Mode Loop Status Time Left(sec)
------------- --------------------- ----------------- -------------
eth3.1 Enabled Normal
eth3.8 Enabled Normal
eth4.5 Enabled Loop 20
Total Entries: 3
Switch#
To Next Page
Loading...
