D-Link DGS-6600-48TS

DGS-6604 m end
CLI Reference Guide
188
end
Use this command to end the current configuration session and go back to the
Privileged EXEC mode.
end
Syntax None
Default None
Command Mode Any configuration mode
Usage Guideline Using this command will end the configuration task in any configuration mode
and go back to the Privileged EXEC mode.
If the current mode in any of the EXEC mode, this command will logout the
session.
Example This example shows how to end the interface configuration and go back to
privileged mode.
Switch(config-if)#end
Switch#