DGS-6604 ip igmp snooping static-group
CLI Reference Guide
279
Example The following example, on the next page, shows how to statically add group and/
or source records for IGMP Snooping.
Verify the settings by entering the show ip igmp snooping group command.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ip igmp snooping static-group 226.1.2.3 interface eth3.5
Switch(config-if)# exit
Switch(config)#interface vlan1
Switch(config-if)#ip igmp snooping static-group 226.1.2.6 source 10.1.2.3
interface eth3.5
To Next Page
Loading...
