DGS-6604 m lldp dot3-tlv-select
CLI Reference Guide
386
Default No IEEE 802.3 Organizationally Specific TLV is selected.
Command Mode Interface configuration.
Usage Guideline The lldp dot3-tlv-select command enables the advertisement of the optional
IEEE 802.3 Organizationally Specific TLVs. The respective TLV will be
encapsulated in LLDPDU and sent to other devices if the advertisement state
is enabled.
Example This example shows how to enable advertising MAC/PHY Configuration/Status
TLV:
This example shows how to disable advertising MAC/PHY Configuration/Status
TLV:
Switch (config-if) # lldp dot3-tlv-select mac-phy-cfg
Switch (config-if) # no lldp dot3-tlv-select mac-phy-cfg
To Next Page
Loading...
