EasyManua.ls Logo

D-Link DGS-6600-48TS

D-Link DGS-6600-48TS
972 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DGS-6604 m match
CLI Reference Guide
420
value from a class map, use the no form of this command. As an example for the
match dscp command, if the user wants to match the DCSP values of 0, 1, 2, 3,
4, 5, 6, or 7 (note that only one of the IP DSCP values needs to be matched, not
all of the specified DSCP values), enter the match dscp 0,1,2,3,4,5,6,7
command. This command is used by the class map to identify the specified
DSCP value on a packet as a match with the traffic class configured.
To identify IP precedence values to use as the match criteria, use the match
precedence command in class-map configuration mode. To remove IP
precedence values from a class map, use the no form of this command. For
example, to use the precedence values of 0, 1, 2, or 3 (note that only one of the
precedence values needs to be matched, not all of the specified precedence
values), enter the match ip precedence 0,1.2.3 command or match ip
precedence 0-3 command.
To configure the match criteria for a class map on the basis of the specified
protocol, use the match protocol command in class-map configuration mode. To
remove protocol-based match criterion from a class map, use the no form of this
command.
To match and classify traffic on the basis of the virtual local-area network (VLAN)
identification number, use the match vlan command in class-map configuration
mode. To remove a previously specified VLAN identification number as a match
criterion, use the no form of this command
The match protocol command specifies the name of a protocol to be used as the
match criteria against which packets are checked to determine if they belong to
the class.
Supported
Protocols:
The following table lists the reference for the supported protocols.
Protocol
Description
arp IP Address Resolution Protocol (ARP)
bgp Border Gateway Protocol
dhcp Dynamic Host Configuration
dns Domain Name Server lookup
egp Exterior Gateway Protocol
ftp File Transfer Protocol
ip IP (version 4)
netbios NetBIOS
nfs Network File System
ntp Network Time Protocol
ospf Open Shortest Path First
pppoe Point-to-Point Protocol over Ethernet
rip Routing Information Protocol
rtsp Real-Time Streaming Protocol

Table of Contents

Other manuals for D-Link DGS-6600-48TS

Related product manuals