DGS-6604 m qos aggregate-policer
CLI Reference Guide
503
Default Not configured
For a two rate policer, the defaults for unspecified options are as follows:
• exceed-action: drop.
• violate-action equals exceed-action
Command Mode Global configuration
Usage Guideline An aggregate policer can be shared by different policy map classes and on
different interfaces. It cannot be shared by different policy map.
For detailed description regarding how to configure the policer, refers to the
usage guideline for police and police cir command.
Note: Either one of qos aggregate-policer NAME command and qos aggregate-
policer NAME cir command can be activated for the refereed traffic class. The
latter command will overwrite the previous qos aggregate-policer NAME setting
once the reference aggregator name are the same.
PEAK-BURST PEAK-BURST Specifies the burst size for the second token bucket in bytes.
min: 4KB
max: 16MB
default: 4KB.
exceed-action Specifies action to take on packets that exceed the rate limit.
violation-action (Optional) Specifies action to take on packets that violate the normal and
maximum burst sizes for singe rate policing. . Specifies the action to take for
those packets that did not conform to both CIR and PIR. For two rates policing.
If violate-action is not specified for single rate policer, it will create a single rate
two color policer.
ACTION Action to take on packets. Specifies one of the following keywords:
"drop-Drops the packet.
"set-dscp-transmit VALUE - Sets the IP differentiated services code point
(DSCP) value and transmits the packet with the new IP DSCP value.
"transmit-Transmits the packet. The packet is not altered.
Syntax Description
To Next Page
Loading...
