DGS-6604 m service-policy
CLI Reference Guide
546
The cust2-classes policy map is configured and then attached to eth4.1by the
following commands.:
Verify the settings by entering the show qos interface command.
Switch(config)# policy-map cust2-classes
Swtich(config-pmap)# class gold
Switch(config-pmap-c)# police 128 256 exceed-action set-dscp-transmit 0
Switch(config-pmap-c)# exit
Switch(config-pmap)# class silver
Switch(config-pmap-c)# police 128 256 exceed-action set-dscp-transmit 0
Switch(config-pmap-c)# exit
Switch(config-pmap)# class bronze
Switch(config-pmap-c)# police 128 256 exceed-action set-dscp-transmit 0
Switch(config-pmap-c)# exit
Switch(config-pmap)# exit
Switch(config)# interface eth4.1
Switch(config-if)# service-policy cust2-classes
Switch(config-if)# exit
To Next Page
Loading...
