DGS-6604 m show ip bgp community-list
CLI Reference Guide
617
Field Description
BGP table version Internal version number of the table. This number is incremental increased or
decreased whenever the table changes.
local router ID IP address of the router.
Status codes Status of the table entry. The status is displayed at the beginning of each line in
the table. It can be one of the following values:
s-The table entry is suppressed.
S- The table entry is stale.
*-The table entry is valid.
>-The table entry is the best entry to use for that network.
i-The table entry was learned via an internal BGP (iBGP) session.
Origin codes Origin of the entry. The origin code is placed at the end of each line in the table.
It can be one of the following values:
i-Entry originated from an Interior Gateway Protocol (IGP) and was advertised
with a network router configuration command.
e-Entry originated from an Exterior Gateway Protocol (EGP).
?-Origin of the path is not clear. Usually, this is a router that is redistributed into
BGP from an IGP.
Network IP address of a network entity.
Next Hop IP address of the next system that is used when forwarding a packet to the
destination network. An entry of 0.0.0.0 indicates that the router has some non-
BGP routes to this network.
Metric If shown, this is the value of the inter-autonomous system metric. This field is
frequently not used.
LocPrf Local preference value as set with the set local-preference route-map
configuration command. The default value is 100.
Weight Weight of the route as set through autonomous system filters.
Path Autonomous system paths to the destination network. There can be only one
entry in this field for each autonomous system in the path.
To Next Page
Loading...
