DGS-6604 m show lldp neighbor interface
CLI Reference Guide
826
Example The following is sample output from the show lldp neighbor interface command
to display information about neighboring devices learned by LLDP on eth4.9 in
detailed mode:
Switch> show lldp neighbor interface eth4.9 detail
Port ID : eth4.9
---------------------------------------------------------------------------
----
Remote Entities Count : 1
Entity 1
Chassis ID Subtype : MAC Address
Chassis ID : 00-01-02-03-04-05
Port ID Subtype : Local
Port ID : 1/5
Port Description : RMON Port
System Name : Switch1
System Description : Stackable Ethernet Switch
System Capabilities Supported : Repeater, Bridge
System Capabilities Enabled : Repeater, Bridge
Management Address Count : 0
(None)
Port VLAN ID : 0
PPVID Entries Count : 0
(None)
VLAN Name Entries Count : 0
(None)
Protocol ID Entries Count : 0
(None)
MAC/PHY Configuration/Status : (None)
Power Via MDI : (None)
Link Aggregation : (None)
Maximum Frame Size : 0
Unknown TLVs Count : 0
(None)
To Next Page
Loading...
