DGS-6604 m telnet
CLI Reference Guide
896
The following example show how to telnet to the IPv6 address
2001:e10:5c00:2::101:253 using default port 23, then enter the escape sequence
: Ctrl-_ and press any other key returning to the telnet session.
The following example show how to telnet to the IPv6 address
2001:e10:5c00:2::101:253 with specific port 3500.
Switch#telnet 2001:e10:5c00:2::101:253
Connecting to 2001:e10:5c00:2::101:253 ...
Connected to Telnet connecting ...
Escape character is 'Ctrl-_'.
Telnet connecting ...
Chassis-based High-Speed Switch
Command Line Interface
Firmware: 2.10.001
Copyright (c) 2010 D-Link Corporation. All rights reserved.
Switch>
Supported commands are:
e - terminate the current Telnet session
If other key is pressed, the terminal will return to the original active
Telnet session.
continuing...
Switch>
Switch#telnet 2001:e10:5c00:2::101:253 3500
Connecting to 2001:e10:5c00:2::101:253 ...
Connected to Telnet connecting ...
Escape character is 'Ctrl-_'.
Telnet connecting ...
Chassis-based High-Speed Switch
Command Line Interface
Firmware: 2.10.001
Copyright (c) 2010 D-Link Corporation. All rights reserved.
Switch>
To Next Page
Loading...
