DGS-6604 m channel-group
CLI Reference Guide
85
• In order to be a member of the LACP channel-group, the member ports
must have the same speed setting. LACP will not prevent the user config-
uration if these ports have difference speed setting in the same channel
group. LACP protocol behavior will choose the members that have the
same speed to for the link aggregation.
Example This example shows how to configure a channel group. It assigns the eth3.4 to
3.5 to port-channel 3 with the LACP mode active.
Verify the settings by entering the show channel-group command
Switch(config)# interface range eth3.4-3.5
Switch(config-if)# channel-group 3 mode active
To Next Page
Loading...
