UCM630X Series User Manual
Version 1.0.11.10
ban the host with a matching address in this list. Up to 20 addresses can be added
to the list descriptions/comments can be added for each whitelist entry for admin
to log what’s the whitelist IP address is for.
Enable Asterisk service for Fail2Ban. The default setting is disabled. Please make
sure both "Enable Fail2Ban" and "Asterisk Service" are turned on to use Fail2Ban
for SIP authentication on the UCM630X.
Configure the listening port number for the service. By default, port 5060 will be
used for UDP and TCP, and port 5061 will be used for TCP.
Configure the number of authentication failures during "Max Retry Duration" before
the host is banned. The default setting is 5. Please make sure this option is
properly configured as it will override the "MaxRetry" value under "Global Settings".
Enables defense against excessive login attacks to the UCM’s web GUI.
The default setting is disabled.
This is the Web GUI listening port number which is configured under System
Settings→HTTP Server→Port.
The default is 8089.
When the number of failed login attempts from an IP address exceeds the
MaxRetry number, that IP address will be banned from accessing the Web GUI.
Customer Service
System Call Defense
Enable call defense in the customer service system. Off by default.
The current service listening port. Default UDP port: 5060, TCP port: 5060, 5061,
WebSocket communication port: 8088.
Set the maximum number of calls allowed in the "time span". The local matching
threshold has a higher priority than the global matching threshold. The default
setting is 5.
Users will be able to view the IPs that have been blocked by UCM.
To Next Page
Loading...
Need help?
General
