Grandstream Networks UCM630X Series - Page 77

P a g e | 77
UCM630X Series User Manual
Version 1.0.11.10
IP Method
Select DHCP, Static IP, or PPPoE. The default setting is DHCP.
IP Address
Enter the IP address for static IP settings. The default setting is 192.168.0.160.
Subnet Mask
Enter the subnet mask address for static IP settings. The default setting is 255.255.0.0.
Gateway IP
Enter the gateway IP address for static IP settings when the port is assigned as the default
interface. The default setting is 0.0.0.0.
DNS Server 1
Enter the DNS server 1 address for static IP settings.
DNS Server 2
Enter the DNS server 2 address for static IP settings.
Username
Enter the username to connect via PPPoE.
Password
Enter the password to connect via PPPoE.
Layer 2 QoS
802.1Q/VLAN
Tag
Assign the VLAN tag of the layer 2 QoS packets for the LAN port.
The default value is 0.
Layer 2 QoS
802.1p Priority
Value
Assign the priority value of the layer 2 QoS packets for the LAN port. The default value is
0.
IPv6 Address
WAN (when "Method" is set to "Route")
IP Method
Select Auto or Static. The default setting is Auto
IP Address
Enter the IP address for static IP settings.
IP Prefixlen
Enter the Prefix length for static settings. Default is 64
DNS Server 1
Enter the DNS server 1 address for static settings.
DNS Server 2
Enter the DNS server 2 address for static settings.
LAN (when Method is set to "Route")
DHCP Server
Select Disable, Auto, or DHCPv6.
• Disable: the DHCPv6 server is disabled.